1963-1983 TOYOTA FAST TRAC TOP INSTALLATION INSTRUCTIONS

download
Step 1. Windshield Slot. Center Windshield slot (Item 1) from side to side on top of windshield frame. Mark and drill 1/8″ holes using windshield slot as a template. Secure with #10 x 1/2″ sheet metal screws (Item 2) through windshield slot, fender washer (Item 3) and into windshield frame. See figure 2. Step 2. Horizontal Rod Bracket. Place holes in horizontal rod bracket (Item 4) over holes on inside corner of windshield frame. Secure with M6 x 12MM bolt (Item 5) through #12 flat washers (Item 6), horizontal rod bracket and into threaded holed in windshield frame. See figure 3. Figure 3 Step 3. Vertical Rod Bracket. Locate holes for vertical rod bracket (Item 7) by placing on top of door post and aligning with top edges of door post. Mark and drill 5/32″ holes using vertical rod bracket as a template. Secure with #14 x 1/2″ sheet metal screws (Item 8) through vertical rod bracket and into drilled holes. See figure 4. Step 4. Belt Rails And Corner Plate. Place belt rail (Item 10) up against rise in body behind the door opening. Secure belt rail to top of body with M6 x 1 x 35 MM hex head bolt (Item 9) through #12 flat washer (Item 6), belt rail 5/8″ spacer tube (Item 11) and into existing threaded hole on body. Butt rear corner plate (Item 12) to end of belt rail. Place a M6 x 1 x 35MM hex head bolt through #12 flat washer, corner plate, 5/8″ spacer tube and into existing hole closest to the tailgate. Do not tighten at this time. Using the corner plate as a template mark and drill 5/32″ holes for remaining mounting holes in corner plate making sure that corner plate is parallel with body and in line with belt rail. Secure with #14 x 1 “sheet metal screws (Item 13). Tighten all fasteners, except the bolt closest to tailgate, at this time. See figure 5. Drill 1/8″ holes in corner plate using tailgate clip (Item 14) as a template making sure that tailgate clip is parallel with corner plate. Secure tailgate clip to corner plate with #10 x 1/2 sheet metal screws (Item 2) and M6 x 35MM hex head bolt through slot in tailgate clip. Place footman loop (Item 15) at a 45 degree angle on top of corner plate. Using footman loop as a template mark and drill 1/8″ holes in the corner plate. Secure footman loop to top of corner plate with #8 x 1/2 “oval head sheet metal screws (Item 16). See figure 5. Step 5. Bow Mount Mark a line on top of belt rail 17 1/4″ from rear of door post. Place the end of bow mount (Item 17) on this fine flush with the inside edge of belt rail. Using outside set of holes in bow mount as a template, drill 5/32″ holes in belt rail. Secure bow mount to body using #14 x 1/2″ sheet metal screws (Item 8) through holes in bow mount. Repeat for the other side. See figure 6.